Product Name: Hydrogen-rich portable pot

Product material: platinum sheet/food grade PC/SPE film

Capacity: 1500ml

Hydrogen concentration: 1200ppb-2400ppb

Battery capacity: 1500mAh

Hydrogen production time: 6min

Hydrogen production times: 10 times

Charging method: USB

Net weight: 260g

Hydrogen water absorbs into your body easily to boost your metabolism and increase the body's micro circulation.

The Q12 hydrogen water generator makes the water in a high hydrogen concentration from 900ppb-2300ppb,ORP from -200mV to -600mV.Most Important,with its high quality of USA DUPONT N117 membrane,it puts only pure H2 into the water. Oxygen, Ozone and Chlorine are separated out. So the hydrogen water you get is 99.99% pure H2 and NO Chlorine,No Oxygen,No H2O2,NO Ozone. Able to attach disposable plastic drinking water bottles,portable for travel,work and office. Any kind of water can be used:Mineral Water,Pure Water,and Distilled Water is welcomed.Additionally,this machine uses PEM and SPE technology to make pure 99.99% H2 hydrogen.

Precautions for using hydrogen rich water bottles:

1. Before use, test the water first. As the pot body and lower base are separate, water leakage may occur during transportation due to bumps. Unscrew the base, check the rubber pad, and tighten it again.

2. Do not use hot water above 80 degrees Celsius. It is best to rinse twice with water at 50 degrees Celsius to achieve 40 degrees Celsius. Otherwise, if it exceeds 45 degrees Celsius, hydrogen will evaporate immediately.

3.It is recommended to use water containing minerals for the best results. Beverages excluded.

4.Do not approach the ignition source during hydrogen production.

5. The number of hydrogen production times should not be too high (1-2 times is the best) to prevent the pressure from being too high, which may cause the base to leak.

6. When producing hydrogen, when the milky white bubbles dissipate, it should be consumed for about 2 minutes before drinking. The taste is better.

7.When it is found that the bubbles in the water have decreased and there is dirt on the pot body, it can be poured into white vinegar, covered and soaked for more than 2 hours, shaken for another 2 minutes, and washed clean with water.

8.Remember not to burn dry. Otherwise, hydrogen will not be produced. The base is burnt out.

9.When carrying it with you, please tighten the cup cover clockwise to avoid leakage.

10.Do not use volatile agents, gasoline, metal wire balls, or hard objects to clean the product to avoid scratching the pot body.

11.If you forget to drink after electrolysis, you can repeat electrolysis to increase the hydrogen content in the water for better results.

12.When cleaning the bottom, it is necessary to use a soft sponge basket, cloth, or soft brush to wipe it clean and keep the bottom dry.

13.When charging, the green light will flash, and after the charging is completed, the green light will stop flashing. Charging once takes 12 hours, and fully charging can produce about 5-6 pots of hydrogen rich water. Due to objective reasons such as water quality and climate in different regions, the number of cups made and charging time may also vary.

14. The hydrogen production time is 10 minutes at a time. After the hydrogen production is completed, the machine will automatically shut down. The blue light of the button will light up during hydrogen production. To forcibly shut down, press the button.